Cracked, broken & damaged water pump dive pulleys are not uncommon as they were originally made from cast iron. Cracks and breaks can occur easily when removing the pulley wheel from the water pump bearing during pump replacement. We now offer replacement pulleys if yours has broken or you are upgrading from a dynamo to a more efficient alternator charging system.
During the development of this pulley it came to our attention that some similar types of replacement pulleys on the market have some design flaws, safety and performance concerns shown below:
Fully CNC machined in house from 6000 series billet aluminium. High strength and excellent corrosion resistance. Machined to original dimensions including precision honed pilot bore for correct fitment to water pump bearing shaft. Can also be supplied with a reduced pilot bore size to allow correct fitment when using aftermarket water pumps & rebuild kits. (More information on request & See below)
If you are using an aftermarket or reproduction water pump or rebuild kit it is very important that you measure the diameter of the bearing shaft. Some rebuild kits and pumps have an inferior bearing and the shaft is too small. This can lead to the water pump drive pulley coming off the shaft when in service. This can, and has caused damage to engine bays, radiators, hoses and cooling fans. Remember the only thing holding a pulley of more than 2kg onto the water pump is the interference fit.
The pulley bore should be a nominal 5/8” (0.625”) 15.875mm
If your bearing shaft measures 0.6288” 15.97mm the shaft is correct and the interference fit between pulley hub and bearing is: .0038”. Correct.
If your bearing shaft measures 0.6265” 15.91mm the shaft is incorrect. The interference fit for carrying a 2.5kg pulley, fan & drive belt loadings is only: .0015”. Simply not enough.
If you already have a reproduction water pump or rebuild kit with a bearing shaft of incorrect size we can reduce the inside diameter of your pulley to ensure you have the correct interference fit as mentioned above. This is a specialist machining operation of internal knurling and does not affect pulley balance.
Our water pump rebuild kits feature correct size bearing shafts, highest quality bearing from USA, 8-vane impellers, bearing locking screw as original design, and high quality mechanical seal. Kit also includes a press tool for fitting the mechanical seal. Available for both SP and Saloon engines.
Pulley wheel removal under normal circumstances is usually straight forward with the use of a hydraulic press. Not in the case of the Daimler V8. The original pulley wheels were made from cast iron and as such brittle and therefore very fragile. If you plan to use the rear of the pulley to press against it will likely crack or break as it is simply not strong enough to support the press load. The smaller dynamo drive pulleys are a little stronger and this method can be successful but if you try and remove the alternator (Dual diameter) pulley, using this method carries a high risk and it usually ends in disaster. Many have tried and many have failed. Second hand replacements are hard to find.
This is our purpose made water pump pulley removal tool specifically made for the Daimler V8 saloon. It will remove both alternator and dynamo drive pulleys from the water pump quickly and safely. It attaches to the face of the pulley using the fan fixing studs and nuts. A fine thread screw with hardened ball end is used to push the against the water pump bearing shaft from the pulley hub. All the press load is through the face hub of the pulley which is the thickest and strongest part of the pulley wheel.
As the Saloon alloy pulley seen above this water pump pulley is for the SP250. Again fully CNC machined from 6000 series billet aluminium. Machined to original specification but wit four added draw bolt holes to aid pulley removal if required. (See our bespoke pulley removal tool below and in the tooling section of this website) This pulley is significantly lighter than the cast iron original pulley. This benefits the water pump bearing and seal arrangement for improved reliability.