Copyright © 2026 J and E Engineering Services Ltd All Rights Reserved
J and E Engineering Services Ltd.
Unit 32 Britannia Mill,
Stoneholme Road,
Crawshawbooth,
Rossendale,
Lancashire.
BB4 8BA.
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Sunday
8:30am -
8:30am -
8:30am -
8:30am -
8:30am -
9:00am -
Closed
Here you can see close up images of the sealing crimp and this is where the SLS aftermarket gasket problems lie. Original gaskets are no longer available and the aftermarket gaskets that are available have a flaw in the pressing of the sealing crimp. In certain areas the crimp is too pronounced which hinders the sealing of gasket. We modify this gasket by pre-
Our modified gaskets are available here
Composite gaskets are available and offer a good solution for over machined cylinder heads as they can be supplied in different thickness. We have seen a few engines where this type of gasket has been utilised and we have been left unimpressed with the construction, material and fit. The images below show how poor the gasket fit is. The combustion fire ring is overhanging the cylinder which could promote detonation and premature gasket failure while the opposing side of the same cylinder you can see the fire ring some distance from the edge of the cylinder wall. To put it simply the layout and geometry of the gasket is incorrect. You can also see that the middle layer of the gasket is a tanged tin plate. This type of construction is better suited to exhaust manifolds as it allows a good amount of distortion in the mating surfaces. Quite forgiving but not good for head gasket sealing as it will require constant re-
Info
No matter which cylinder head gasket you choose you must ensure the cylinder block decks (Gasket faces) are not excessively distorted. Everyone knows that the alloy cylinder head can warp and this can be easily rectified by machining (Skimming) the head faces. The cylinder block can and will suffer from the same issues and this is often overlooked by repairers and engine builders. The rectification for this problem is again machining or skimming but it will require engine removal, full strip & rebuild in order to do so. Whichever gasket you choose to use, neither will seal correctly if the block faces are distorted or warped. Below you can see what warped or distorted cylinder block decks look like during a full strip down. The other images show the cylinder block gasket faces during machining and you can clearly see the low areas of distortion around the coolant passages and cylinders.
The original cylinder head gasket is a single layer steel construction “SLS” type. This head gasket was ahead of its time when it was introduced and this type of gasket has been adopted by many engine manufacturers and is currently used today in modern engines. Once torqued correctly this gasket will provide a more than adequate seal for both coolant and combustion seals. The opposing surfaces of the gasket both cylinder head and cylinder block will need to be in good condition for this type of gasket to be effective. The surfaces must be flat with no deformation due to previous overheating and the surface finish must be kept well under 30 µin (Micro inches) Ra (Roughness average) for both cast iron and alloy mating surfaces.